PENGENDALI POSISI MOTOR DC DENGAN PID MENGGUNAKAN METODE ROOT LOCUS

Agus Nuwolo(1*), Adhi Kusmantoro(2)


(1) 
(2) 
(*) Corresponding Author

Abstract


Position control using a motor is important at this time, especially in the industry. This control is used to move the conveyor so that it will stop at a designated place. Another application is to move the robot arm to a certain position. The development of control technology is so rapid now allow control is done digitally. The resulting simulation can be used to design a PID controller algorithm. Root locus design results in a PID controller generates 13.6% overshoot and settling time of 0.0386 seconds. With the interference of external PID controller is still able to cope with disturbances. To improve the quality of DC motor position controller is recommended to use logic controller Fuzi (fuzzy logic).


Keywords: control position, Motor DC, Root Locus


Full Text:

PDF

Article Metrics

Abstract view : 1316 times
PDF - 380 times

DOI: https://doi.org/10.26714/me.v7i1.1311

Refbacks

  • There are currently no refbacks.


Bookmark and Share


Copyright (c)



Editorial Office of Media Elektrika

Universitas Muhammadiyah Semarang FT-FMIPA Building, 7nd Floor. 
Department of Electrical Engineering
Jl. Kedungmundu Raya No. 18, Kota Semarang, Prov. Jawa Tengah, Indonesia 50273

Phone: 085299398663
Email: [email protected]

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.