STUDI PEMBUATAN SCAFFOLD BOVINE HYDROXYAPATITE DARI TULANG SAPI UNTUK APLIKASI IMPLAN TULANG MANDIBULA MENGGUNAKAN METODE KALSINASI

Solechan -(1*), Saifudin Alie Anwar(2)


(1) 
(2) 
(*) Corresponding Author

Abstract


Waste cow bone bakso balungan in Central Java own produces 31.9 tons/day of merchants bakso. Bovine bone hydroxyapatite material can be made bioceramik derivative products to repair damaged hard tissues of the body due to brittle bones, bone cancer or accidents. Tissue damage including bone tumors. Tumors of the mandibular potentially cause interference and need removal of mandibular tumors that cause cracks.
It is necessary for the formation of mandibular reconstruction of mandibular continuity with transplantation scaffolds. The use of limited donor transplanstasi, whereas synthetic implant material is very expensive. Preparation of bovine hydroxyapatite scaffold waste cow bone bakso balungan of reinforced PCL with calcination method would be less
costly. The process of manufacture of bovine bone hydroxyapatite by cutting waste kanselosa in size 10 mm x 10 mmx 10 mm, and then calcined at 300, 6000, 900, and 1200 oC for 2 hours. Furthermore PCL scaffold is reinforced with a concentration of 1, 3, and 5%. by means of dip coating for several minutes. Bovine hydroxyapatite scaffold tested showed an increase XRD diffractogram with the calcination temperature gave
sharp peaks with high intensity high crystal or crystalline form perfect but with the addition of PCL deficient diffraction process with a decrease inttensitas. The pore size and porosity influenced the high calcination but lower compressive strength. With the addition of the PCL layer increases the compressive strength, but decrease the pore diameter and porosity that is still under scaffolds characteristics and mechanical properties of commercial.

Full Text:

PDF

Article Metrics

Abstract view : 388 times
PDF - 161 times

DOI: https://doi.org/10.26714/traksi.14.2.2014.%25p

Refbacks

  • There are currently no refbacks.


Copyright (c)

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.


TRAKSI : Majalah Ilmiah Teknik Mesin

ISSN : 1693-3451 (Pinted) e-ISSN : 2579-9738 (Online)

Published by: LP2M Unimus bekerjasama dengan APTI (Asosiasi Profesi Teknik Indonesia)  

 
ADDRESS

Jl. Kasipah No. 12 Semarang

E-mail: traksi@unimus.ac.id Call: 0248445768


Sponsors

Asosiasi Profesi Teknik Indonesia (APTI)

Website: www.apti.or.id